Carried in massive yoke on Ø10mm precision ball races. Stainless steel cross shaft, ground and thread ground.Fine machined cartridge platform, enamel free to avoid interface resonance.Internal constrained layer damps minute residual vibration leaving the tone-arm acoustically inert.The 12in pressure die-cast tone-arm utilises the advantages of magnesium and exploits the reduction in maximum tracking error/distortion afforded by the greater arm length when compared with 9in models.Listening: the benefits of minimal tracking error and harmonic distortion are clearly revealed. The 12 inch tone-arm is pressure die-cast in magnesium complete with an Integrated headshell to eliminate tone-arm resonances in the audio spectrum and offers a 27% reduction in maximum angular error distortion over 9 inch models. Startling dynamic range, neutrality, structurally inert, the Series V-12 embodies every worthwhile feature in a pick-up arm. Coherent musical control is held over the entire frequency range in terms of tonal quality, stability and stereo imaging. See on photos position for diamond tip ( OVERHANG) marked by red arrow and lines on ALL Kuzma tonearms, which is in the middle of the edge of headshells.Based on the multi-award winning Series V pick-up arm, the Series V-12 incorporates the same design and engineering that have made SME a byword for excellence.
But it is possible to find a way around with min height of 25 mm ( removing height ring: gain 5 mm, adding ballast plate: gain 3 mm, using thinner armbase: gain 5 mm, set up VTA scale higher: gain 3-4 mm.) or even 20 mm/ with VTA adjustment restricted.ĭistance from spindle to horizontal bearing (mm) for 4Point tonearms with VTA towers required min height is 34 mm. If you find out that your turntable has a small height from top of the mat to the top of the armboard consult us: ie.
To fit some Kuzma tonearms on various turntables consult Manual section: floor and side views drawings. But most of Kuzma tonearm can be mounted on SME cutout - we provide SME-Kuzma adaptor! Note: Kuzma tonearm mounting- we use standard Kuzma cutout- see details elswhere.
0 kommentar(er)
